03-29-2025, 02:33 PM
I have a clip in the audio editor and I want to align the beats to the editor so I can count forward and back by beats. I have the ruler set to Beats. I'm able to use the selection grid (which is really cool!) to drag out four beats. I've also seen how I can use the left mouse down to increase and decrease the Tempo which does slide the ruler.... but I still can't align it so I can't get the correct temp either. I've uploaded a picture to show how far I got so far (#1 and #2)
The workflow I was hoping for was:
1) Drag out a selection grid of exactly 1 bar.
2) Slide the ruler to move the ruler's first bar of a measure to the beginning of my selection. (705.1 in this example).
3) Anchor the ruler so that it won't move when I drag the tempo indicator.
4) Drag the tempo up and down until the 4 beats (705.1->706.1) align with my selection.
At this point, as long as the song is consistent I should be able to easily identify the beats.
is this possible? I've tried various combinations but not been able to do this.
Thanks!
By the way, loving the software so much! I just purchased the Perpetual License.
The workflow I was hoping for was:
1) Drag out a selection grid of exactly 1 bar.
2) Slide the ruler to move the ruler's first bar of a measure to the beginning of my selection. (705.1 in this example).
3) Anchor the ruler so that it won't move when I drag the tempo indicator.
4) Drag the tempo up and down until the 4 beats (705.1->706.1) align with my selection.
At this point, as long as the song is consistent I should be able to easily identify the beats.
is this possible? I've tried various combinations but not been able to do this.
Thanks!
By the way, loving the software so much! I just purchased the Perpetual License.